Texture Coatings & Acrylic Renders
Main menu
Start your project here
Please enter the code in below box.
Texture Coatings & Acrylic Renders

E.I.F.S. Impact Render

EIFS Impact is a polymer and silicate modified, mineral based, trowel-on skim coat specifically designed for application to polystyrene foam panel.


A Pre-Blended, Polymer Modified,
Cement Impact Coat For Polystyrene Foam.


The product is trowel applied to the face of foam panel in a thin section of 1 to 1.5mm in combination with fibre reinforcing sheet. The cured film creates a tough impact resilient surface to the normally soft foam, making the foam suitable for use as a lightweight panel for the construction of exterior walls and fencing.

The product is supplied in a 20 kg paper sack. On site or factory mixing requires only the addition of fresh clean water to a desired consistency. No additional polymer additives are required and should not be added.


Pack Size
Mix Activation Water
Drying Time @ 25°C
[55% Relative Humidity]
Recommended Thinners
Wash Up
Initial Set Time @ 25°C
Minimum Application Temperature
Finish Colour
20kg Paper Sack
4.0 to 4.4 litres per bag
6 hours [Will vary with
changes in temperature,
humidity and residual
substrate moisture]
30 to 60 minutes
Light Grey
Exterior / Interior
[Must Be Top-Coated]
Not Required
Theoretical Spread Rate @ 1.5mm
m2/20kg Bag


Suitable Substrates:

Polystyrene and Cast Foam.
Satin Enamel

  • Impact

Product downloads
Astec Energy Star | Exterior Paint | Heat Reflective Paint | Paint | Professional Paint | Render | Roof Paint | Texture Coating System | Texture Finishes | Texture Paint | Waterproofing | XML Sitemap | Sitemap