E.I.F.S. Impact Render

EIFS Impact is a polymer and silicate modified, mineral based, trowel-on skim coat specifically designed for application to polystyrene foam panel.

A Pre-Blended, Polymer Modified,

Cement Impact Coat For Polystyrene Foam.

The product is trowel applied to the face of foam panel in a thin section of 1 to 1.5mm in combination with fibre reinforcing sheet. The cured film creates a tough impact resilient surface to the normally soft foam, making the foam suitable for use as a lightweight panel for the construction of exterior walls and fencing.

The product is supplied in a 20 kg paper sack. On site or factory mixing requires only the addition of fresh clean water to a desired consistency. No additional polymer additives are required and should not be added.

Pack Size

Mix Activation Water

Drying Time @ 25°C

[55% Relative Humidity]

Recommended Thinners

Wash Up

Initial Set Time @ 25°C

Minimum Application Temperature

Finish Colour

Durability

Curing

20kg Paper Sack

4.0 to 4.4 litres per bag

6 hours [Will vary with

changes in temperature,

humidity and residual

substrate moisture]

Water

30 to 60 minutes

5°C

Light Grey

Exterior / Interior

[Must Be Top-Coated]

Not Required

COATING THICKNESS

Theoretical Spread Rate @ 1.5mm

m²/20kg Bag

16.67

kg/m²

1.2

Suitable Substrates:

Polystyrene and Cast Foam.

Impact

Product downloads